5 Mounting the PS
5.1 Layout and mode of operation
The "PS 800 M1" pneumatic seed drill is a spreader and seed drill with a total capacity of
800 litres.
The meter roll is driven by a 12 V electric gear motor, which is regulated by the control
box. The speed of the meter roll can be comfortably regulated from the driver's seat using
the control box. Here, there is the option of using speed sensors (see operating
instructions for the control box) to regulate the speed of the meter roll according to the
ground speed!
Power can be supplied to the control box either through the 3-pin standard socket or
optionally directly from the battery.
The blower fan is driven by a hydraulic motor, which is controlled via a valve. This can be
used to adjust the speed of the blower fan impeller and therefore the working width and
the required air volume for various seed types! The implement also has a pressure sensor
in the air flow and a fill level sensor for monitoring.
5.2 Mounting on an implement
To mount the PS 800 M1 on an implement, you must
ensure that the intended carrier or the design is capable
of carrying a load of at least two tons without suffering
damage!
If this is not given, both devices can be damaged!
The contact area must have a minimum dimension of
560 x 800 mm!
Fig.: 1
To Next Page
