42
Quality for Professionals
• The implement has the following maximum noise emission values:
- Emission sound pressure level L
PA
= max. 103 dB
- Sound power level L
WA
= max. 109 dB
Based on EN ISO 3746:2005
The measurement uncertainty is approx. +/- 2dB
• Hearing protection must be worn when using the implement.
• If possible, the selected blower fan speed should not be too high.
13.3 Mounted implements
• Before mounting and dismounting implements on the three-point linkage, move the
operating devices into the position that excludes unintentional lifting or lowering!
• For three-point mounting, the mounting categories of the tractor and the implement
must match or be adapted!
• There is a risk of injury due to crushing and shearing points in the area of the three-
point linkage!
• Do not stand between the tractor and the implement when actuating the external
controls for the three-point mounting!
• When the implement is in transport position, always ensure that the tractor three-
point linkage is sufficiently locked to the sides!
• When driving on roads with the implement lifted, the operating lever must be locked
against lowering!
13.4 Maintenance
• Maintenance, repair, and cleaning work as well as the elimination of malfunctions
should always be performed when the drive is switched off and the motor is at a
standstill! – Remove the ignition key! – Switch off the implement!
• Check the nuts and bolts regularly for tight fit and retighten if necessary!
• When performing maintenance on the lifted implement, always ensure safety
through suitable support elements!
• When changing work tools with sharp edges, always use suitable tools and gloves!
• Properly dispose of oils, grease and filters!
• Always cut the power supply when working on the electrical system!
• When performing electrical welding work on the tractor and mounted implement,
disconnect the cable on the generator and the battery!
• Spare parts must at least comply with the technical requirements specified by the
implement manufacturer! This is ensured with original parts!
• Do not clean the implement with water. It is recommended to clean the implement
with compressed air.
PLEASE NOTE: Misprints, errors and omissions excepted.
To Next Page
Loading...
Need help?
General
