ilux Digital Bath with diverter installation instructions Page 11
Installation instructions – Bath with diverter
Unscrew the single fixing on top of the
processor and Digital diverter box and carefully
tilt the lids up and off the location lugs and pull
the lids clear.
16
17
Connect the 10m low voltage data cable into
the socket adjacent to the temperature adjuster
as indicated on the label. Feed the cable out of
the processor box ensuring it is correctly routed
within the data cable channel.
The processor secondary socket MUST be used to connect the processor to the
diverter valve. This is located next to the processor main socket and is accessed
by carefully snapping and removing the entry pillar.
!
BEFORE ANY ELECTRICAL ADJUSTMENT IS ATTEMPTED, THE ELECTRICITY
SUPPLY MUST BE TURNED OFF AT THE MAINS SWITCH.
ELECTRICAL INSTALLATION MAY ONLY BE CARRIED OUT BY A QUALIFIED
PERSON.
!
To Next Page
Loading...
