Aqualisa Midas - Deck Mount Installation

14
The Midas range bath/shower mixers feature inlet pipe centres of 150mm. However deck mount adaptors are provided to
allow installation to baths at standard 180mm centres.
1
Ensuring the fibre washers are fitted within the valve inlets, attach the deck mount adaptors to
the bath/shower mixer. Tighten the connections using a suitable tool, taking care not to
overtighten.
2
Place the rubber washers onto the tap tails and offer the assembly into position onto the bath.
3
Place the back nuts onto the tap tails and secure the assembly to the underside of the bath.
Deck mount installation
5
Turn on the supplies to the bath/shower mixer and turn the flow control knob on to flush the system through. Turn off
the bath/shower mixer.
If required, refer to the commissioning instructions on page 21 to adjust the maximum temperature override button position.
Follow the shower head system installation instructions on pages 15 to 18 to complete the installation.
4
Using suitable connections connect the tap tails to the hot and cold supplies.