Aqualisa Midas - Page 18

18
9
Connect the hose to the valve outlet, ensuring the hose washer is correctly fitted to allow the water to discharge safely to
waste and run the shower for a few seconds to clear any debris in the outlet assembly.
8
If required, optional outlet flow regulators can be purchased from the Aqualisa customer helpline on 01959 560010.
Fit the relevant flow regulator into the brass housing ensuring the O’ring faces the incoming flow. Connect the flow
regulator assembly to the valve outlet ensuring the hose washer is correctly fitted.
!
Outlet flow regulators are not suitable for products fitted to combination boiler systems.
10
Turn off the shower and pass the hose through the gel hook/hose restraint (if required).
11
Disengage the pivot clip and remove the pivot from the bottom of the handset.
12
Ensure the hose washer is in the correct position and screw the pivot into the hose, using a
suitable hexagonal key to tighten, taking care not to over-tighten.
13
Reinsert the pivot into the handset and engage the pivot clip prior to placing the handset into
the handset holder.