Run the shower for a few seconds to clear any debris and to check for any leaks.
Fit the 15mm ‘O’ ring against the end of the fixing bush.
Lubricate the ‘O’ ring using a suitable silicone based
lubricant.
6
Refit the shower arm and secure it to the wall using
the screws provided (if suitable).
7
The ‘O’ ring must be positioned on the 15mm pipe flush to the fixing bush, not
onto the fixing bush shaft.
Slide the cover plate into position flush with the
finished wall surface.
8
Ensuring the rubber washer is in the correct posi-
tion, attach the shower head to the fixed arm and
carefully secure using a suitable spanner, or a tool
with smooth jaws, suciently to lock the head into
position.
9
To Next Page
Loading...
