Aqualisa SMART - Removing Bath Waste Clicker Assembly; Positioning and Securing Bath Waste; Connecting Bath Waste to Trap; Positioning Bath Outlet Body Assembly

Carefully unscrew and remove the bath waste clicker
assembly from the waste body and set aside.
2
Oer the bath waste into position ensuring the rubber
washer is correctly aligned between the waste assembly
and the bath base.
3
Ensuring the rubber washer is correctly aligned, pass the
bath waste clicker through the bath and secure to the
waste body assembly.
4
Connect the bath waste to a suitable trap (not supplied).
5
Oer the outlet body assembly into position at the rear of
the bath ensuring the rubber washer is correctly aligned
between the outlet body assembly and bath wall.
6