Aquatic Industries, Inc. 21
The whirlpool action may cause even small amounts of bubble bath or shampoo to foam excessively. Exercise
moderation in experimenting with different soap products.
No servicing of this product should be done by the user. There are no user serviceable parts. All controls
are located in the control recesses on the lip of the tub. These are the only controls that should be used by
the consumer. Do not change or alter any of these controls under any circumstances.
Motors are self-lubricating -- No lubrication required.
This equipment generates and uses radio frequency energy and if not installed and used
to radio and television reception. It has been type tested and found to comply with the limits
for a class B computing device in accordance with the specifications in subpart J of part 15 of
or more of the following measures:
circuits.
for additional suggestions.
This booklet is available from the U.S. Government Printing Office, Washington, DC 20402,
Stock No., 004-000-00345-4.
WHIRLPOOL USER INFORMATION
PLEASE NOTE:
FCC CONSUMER INFORMATION
Electrical Installation Information Listed on pages 11-14.
Serial Number Location
The tub model and serial number
is located above the pump area on the backside
of the bathtub. Your installer should have a service
access panel in this location.
To Next Page
