22 Aquatic Industries, Inc.
MAINTENANCE AND CARE
INITIAL CLEANING:
putting whirlpool into service. DO NOT USE ABRASIVE CLEANERS ON THE ACRYLIC FINISH. Use a non-abrasive
detergent and rinse well after cleaning.
to the water.
Note:
WHIRLPOOL SYSTEM CLEANING:
140
o
NOTE: DO NOT TURN THE PUMP ON DURING THE AIR BATH CLEANING.
least six inches above air injector holes. Add 2 teaspoons of low sudsing automatic dishwashing detergent and no more
than 4 ounces of bleach to the water. DO NOT use bleach or other chlorinated cleansers on metal trim surrounding control
panels. Turn blower on for approximately two minutes to mix cleaner with water. Shut blower down and allow cleaner
to soak in the bath for approximately two hours. Turn ON air bath and run for approximately five minutes. Turn air bath
unit OFF and drain tub. Aquatic recommends the above cleaning process on your air bath system once a month.
NOTE: DO NOT USE OIL OR OIL BASED BATH ADDITIVES.
whirlpool action intensifies the foaming properties of soaps.
The use of certain bubble baths and bath additives may increase the level of accumulations of bath residue in the
If you have followed the monthly purging instructions and still have an excess accumulation of bath residue and desire an
SUPER SYSTEMS CLEAN PLUS manufactured by Stearns Packaging
recommended that you follow the instructions provided by the manufacturer with the product. Repeated use may be
necessary. SUPER SYSTEMS CLEAN PLUS does not replace the necessity to purge your whirlpool system at least
twice a month with a low foaming detergent and bleach.
AIR BATH SYSTEM CLEANING:
To Next Page
Loading...
