Aquatic Industries, Inc. 11
INSTALLATION INSTRUCTIONS
WARNING:
PROCEDURES.
WARNING:
THE FOLLOWING:
DANGER: RISK OF ELECTRIC SHOCK!
GFCI’s are not supplied, however we do specify their use.
All known code authorities require GFCI’s.
Infinity baths will need to be hard wired to the outlets provided. See the following directions and diagram.
Two junction boxes will be mounted to the frame of the whirlpool. One of the two boxes will have one outlet and will be
wire to the neutral side of the receptacle and the green wire to ground. Replace the cover and plug in the blower. (See
diagram on page 12).
Run Romex 14/3 with ground from a 15 amp 2-pole GFCI breaker (not supplied) located in the breaker panel. Connect
the white wire (neutral) to both neutrals of the two outlets. Connect the red wire (hot) to the hot terminal of the outlet
wire (ground) to the ground terminal of the outlet. Replace the cover of the junction box. Find the cord labeled “Heater
Both of these cords will come from the right side of the heater and will be marked. (See diagram on page 12).
CONTINUOUS WATERFALL (INFINITY 1):
The Infinity 1 is equipped with a continuous waterfall that is powered by a recirculation pump. The recirculation pump
ELECTRICAL INSTALLATION:
To Next Page
