Aquatic Industries, Inc. 9
SEE ILLUSTRATION 2A
A. Install the whirlpool bath unit per the instructions provided in this manual.
CAUTION: THE TILE FLANGE DOES NOT SUPPORT THE TUB! A ledger board must be provided under the
as this will void your warranty.
B. Use nails or screws to secure the flange into the studs around the bath.
C. Install water resistant drywall against the tile flange and flush to the top of the whirlpool deck. Install the tile or other
finishing materials. Apply a second bead of silicone between the first course of tile and the bath deck.
FACTORY INSTALLED TILE FLANGE:
NOTE: Before tub is used, the whirlpool system should be cleaned in accordance
with the procedures on Page 22 of this manual.
2A
INSTALLATION INSTRUCTIONS
with water to overflow and operate pump for 5 minutes. Check for leaks carefully both while pump is running and
has been turned off. Allow water to stand in tub for at least 30 minutes before draining. AQUATIC INDUSTRIES,
INC. WILL NOT BE RESPONSIBLE FOR WATER DAMAGE OF ANY KIND IN CONNECTION WITH ONE OF OUR
WHIRLPOOL BATHS.
drilling or cutting tub.
PLUMBING:
To Next Page
Loading...
