© 2020 Araknis Networks
®
17
Araknis Networks AN-210/310-SW-F/R Manual
Product Manual
Table of Contents
Direct Access Using LAN IP Address (DHCP)
1. Use one of these methods to find the IP address of the switch:
• Check the client table on your router
• Use a network scanner (e.g. Fing) to sni the network. The manufacturer field will display SnapAV.
• See the highlighted field in the figure below for an example of an Araknis device being identified.
2. Enter the IP address in your web browser to load the login screen. Enter your username and password,
then click Log In.
3. If you were able to log in successfully, go to the System Settings menu to begin completing the
recommended setup for all users. See section “5 - Recommended Setup – System Settings” on page
28.
4. If this access method does not work for your application, see the next section for instructions to access
the interface using the switch’s default IP address.
Default Login
Username araknis
Password araknis
To Next Page
Loading...
Need help?
General