28/02/2020 Page 2 of 41 ARB Copyright 2018 3789452
If you have any queries regarding the installation of this product please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190
CARE OF YOUR CANOPY:
Please refer to the “owner’s manual supplement” to be given to the purchaser on
installation, and to details referred to in the second last page of these fitting instructions.
HAVE AVAILABLE THESE SAFETY ITEMS WHEN FITTING PRODUCT:
NOTE: ‘WARNING’ notes in the fitting procedure relate to OHS situations, where to avoid a potentially
hazardous situation it is suggested that protective safety gear be worn or a safe work procedure be
employed. If these notes and warnings are not heeded, injury may result.
TOOL LIST FOR FITMENT:
• Torque Wrench 0-25Nm
• Sockets 10 & 13mm, extension bar and
driver
• Spanners, ratchet type, 10 and 13mm.
• 300mm ruler
• 150mm ruler
• T30, T40, Torx Drive screwdriver and bits
for socket drives and screw drivers
• Power or pneumatic drill
• Pneumatic rivet gun.
• Drill bits, 5.2, 6.5mm
• 12mm deep drill stops for 5.2 & 6.5mm bits
• Jig saw
• Knife/Box cutter
• Scissors
• Plastic de-burring tool or sander with disc
• File or sheet metal de-burring tool
• Engineer’s scribe
• Sheet metal vice grip clamp
• Quicklock G clamp
• Centre punch
• Silicon Caulking Gun
• Neutral cure Non Acetic Silicon
• Phillips head screwdrivers
• Flat blade screwdrivers
• Side Cutters
• Squeegee
• Non-permanent marker
• Masking tape
• Cleaning cloths / rags
• Cable ties 9 x 600mm long
• Cable ties 2 x 200mm long
To Next Page
Loading...
