If you have any queries regarding the installation of this product please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190
FITTING THE CANOPY IS UNDERTAKEN IN 6 STAGES:
1. Removing any sports bars, cabin guards and bed liners.
2. Fitting the tub mounting brackets. (Note details of fitting with bed liners refer to
Section 6)
3. Fitting vehicle wiring.
4. Fitting the canopy to the vehicle
5. Operational checks and adjustment options for doors and windows.
6. Fitting the tub mounting brackets with bed liners.
7. Recording of key code and owner’s manual supplement.
8. Check list and sign off.
NOTE: DURING THE INSTALLATION IT IS NECESSARY TO DRILL SOME HOLES THROUGH
THE VEHICLE’S TUB SHEET METAL. IT IS RECOMMENDED THAT THESE ARE DE-
BURRED AND THE RUST INHIBITOR THAT IS PROVIDED BE USED TO AVOID RUST
& ANY SWARF LEFT OVER SHOULD BE CLEANED FROM TUB.
Screw torques must be adhered to avoid warranty issues and should be checked at
vehicle service intervals.
THE FITTING KIT CONTAINS:
Packed under the canopy are:
Qty 1 Front Head Board Mount Rail (Part no 668PD067):
To Next Page
Loading...
