28/02/2020 Page 21 of 41 ARB Copyright 2018 3789452
If you have any queries regarding the installation of this product please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190
3.23) Pull the end connector out through the hole from
under the vehicle and seat the grommet into the
hole in the floor pan.
3.24) Silicon seal all around the grommet to seal it to
the floor pan.
3.25) Moving rearwards along the LH chassis rail, apply
one 450mm long cable to the loom on top of the
chassis rail, ensuring this is NOT tied to brake
or fuel lines.
To Next Page
Loading...
