15-02-2019 Page 14 of 44 ARB Copyright 2019 3789507
If you have any queries regarding the installation of this product please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190
2.21) Apply neutral cure silicon to the ends of the rubber
bridge extrusions and seal down the front side of
the corner of the tub.
2.22) Prepare a pair of rear tub mounting bracket
(668PD077) with self-adhesive bumpons
(665076) applied to the tags on each bracket.
2.23) Locate the rear mounting brackets (668PD077)
toward the rear of the tub’s top side rails.
Measure 950mm between the edges of the tags
overlapping the sides of the tub edge on the front
bracket to the leading edge position of the rear
bracket as shown.
To Next Page
Loading...
