15-02-2019 Page 26 of 44 ARB Copyright 2019 3789507
If you have any queries regarding the installation of this product please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190
4.23) Place a Quicklock clamp over the mount rail of
the canopy and the sheet metal flange of the tub
rearward of the lift up window lock mechanism
cover. Clamp this in position ensuring the
metal mount rail of the canopy is kept
straight and flat.
4.24) Place an M8x19mm (smaller) washer over an
M8x25 Torx pan head screw and locate this into
the slot in the canopy mount rail from the top
inside the lock mechanism bracket cover for lift
up windows. Hold this in place using a socket
drive T40 Torx bit.
4.25) Bring the centre mount rail bracket (668PD054)
up onto the screw via the slotted hole in the
bracket and secure in place with M8x25mm
(larger) washer and M8 nylock nut from the
underside, tightly, pushing the bracket hard up to
the tub flange.
4.26) Using a 6.5mm drill and fitted with a 12mm deep
drill stop to prevent damage to the external skin
of the vehicle’s tub, drill through the tub lip flange
via the hole in the bracket.
De-burr the hole and apply rust inhibitor.
To Next Page
Loading...
