10 | Automate
™
Programming Instructions | 15 Channel Remote
OR
OR
Check motor direction6.1
Damage to shade may occur when operating motor prior to
setting limits. Attention should be given.
Reversing motor direction using this method is only possible
during initial set-up
Direction change will not occur if switch is locked.
See Section 6.3.
To check travel direction of shade, press UP or
DOWN on controller.
Quick Press = Step
Long Press = Continuous Travel
To reverse shade direction, hold both
UP AND DOWN until the motor responds.
Approx.
Motor Response
IMPORTANT
IMPORTANT
6 INITIAL SET UP
SECS
5
Set Limits6.2
Cycle shade up and down prior to setting limits to settle fabric
For systems using FT Motors & the Ultra Lock, the bottom limit should be set ~ 1.38 in. (35mm) below the Ultra-Lock to disengage the auto
lock mechanism when the shade is raised.
After setting limits, motor will automatically exit from initial
set-up mode.
Move shade to the desired highest or lowest
position by pressing the UP or DOWN buttons
on controller.
To save upper limit, hold UP AND STOP.
To save lower limit, hold DOWN AND STOP.
Motor Response
IMPORTANT
IMPORTANT
Initial set-up is not complete
IMPORTANT
Approx.
+
+
+
To Next Page
Loading...
