Automate
™
Programming Instructions | 15 Channel Remote | 5
Remove cover from remote press gently in and
down to disengage cover.
Install battery with positive (+) side facing up.
Slide to remove Snap covers back together.
Remote battery3.1
3 INSTALLATION
Wall mount holder3.2
Use supplied fasteners and anchors as needed to attach the base and cover.
Switch is held in position magnetically and can be removed as desired.
Safely dispose of any unused plugs.
Remove cover from base by prying with flat head
screwdriver.
Use supplied fasteners and anchors to attach the
base to the wall.
To Next Page
Loading...
