ARC Automate - Programming the Remote; Protocol Selection (ARC;EL); Motor Pairing (P1 Button)

8 | Automate
™
Programming Instructions | 15 Channel Remote
Approx.
Approx.
Using motor P1 button
Protocol selection
5.2
5.1
5 PROGRAMMING
Multiple motors can be grouped onto shared channels for co-ordinated control. Limit settings and favorite positions cannot be adjusted when
motors are grouped together.
• Confirm that motor limits and favorite position are already set for each individual motor.
• Ensure that each motor you want to group is also assigned to another channel by itself
Screen Flashes "1" = ARC MODE
Screen Flashes "2" = EL MODE
Hold P2 whilst inserting the
battery
Screen flashes x 5
IMPORTANT
Select a channel on switch
using the CHANNEL UP or
CHANNEL DOWN button(s).
OR
Hold P1 button on motor
head.
Hold STOP on switch.
Motor ResponseMotor Response
Display Response
RELEASE P1
This device can be configured to operate Rollease Acmeda line "EL" motors.
(The default mode is ARC protocol.)
To toggle between ARC & EL modes, follow the following steps.
+