Arcam AV888 - Specifications; Power Output and General Specs; Input, Output, and Accessory Specs

E-62
Continuous power output (20Hz—20kHz at 0.05% THD), per channel
(AVR600)
2 channels driven 150W
All channels driven 120W
THD at full rated power <0.2%
Residual noise & hum <0.25mV unweighted 20Hz – 22kHz
Continuous power output (20Hz—20kHz at 0.05% THD), per channel
(AVR500)
2 channels driven 120W
All channels driven 100W
THD at full rated power <0.2%
Residual noise & hum
Inputs
Phono input:
Input sensitivity at 1kHz 5mV
Input impedance 47kΩ
Signal/noise ratio (CCIR, 65W) 88dB
Overload margin 31dB
Line inputs:
Nominal sensitivity 500mV–4V (user adjustable)
Input impedance 47kΩ
Signal/noise ratio (CCIR, 65W) 100dB
Preamplier outputs
Max output level 6V RMS
Output impedance <50Ω
THD+N (20Hz—20kHz) -100dB
Video inputs
Component video signal/noise 85dB
Composite video signal/noise 70dB
Headphone output
Maximum output level into 600Ω 4V p-p
Output impedance <5Ω
Continual improvement policy
Arcam has a policy of continual improvement for its
products. is means that designs and specications
are subject to change without notice.
specications
General
Mains voltage 110–120V or 220–240V
Power consumption (maximum)
AVR500/AVR600 1.5kVA (ermal dissipation approx.
2300 BTU/hour)
AV888 120VA (ermal dissipation approx.
410BTU/hour)
Power consumption (idle, typical) 120VA (ermal dissipation approx.
410 BTU/hour)
Power consumption (standby) 3VA
Dimensions W x D x H (including feet) 432 x 450 x 180mm
Weight (net)
AVR500 23.0kg
AVR600 25.0kg
AV888 12.0kg
Weight (packed)
AVR500 28.0kg
AVR600 30.0kg
AV888 17.0kg
Supplied accessories Mains lead
CR102 remote control
4 x AAA batteries
Manual
HDMI lead support bar
DAB aerial (if DAB module tted)
FM aerial (if AM/FM tted)
AM loop aerial (if AM/FM tted)
Calibration microphone
E&OE
NOTE: All specication values are typical unless otherwise stated.