remote
control
Inserting batteries into the
remote control
1. Open the battery compartment by pressing the
button on the back of the remote control.
2. Insert two ‘AAA’ batteries into the battery
compartment, following the polarity indications
given inside the compartment itself.
3. Push the battery cover back into position.
Using the remote control
Please keep in mind the following when using the remote
control:
< Ensure that there are no obstacles between the
remote control and the remote sensor on Solo
Mini. The remote has a range of about seven
meters.
< Remote operation may become unreliable if
strong sunlight or fluorescent light is shining on the
remote sensor of Solo Mini.
< Replace the batteries when you notice a reduction
in the operating range of the remote control.
General Solo Mini commands
2
Switches Solo between Clock mode and
On.
DISP
Cycles the brightness of the front-panel
display. The brightness for clock mode
may be set to a different value from the
normal power on mode.
Source
selection
Press the appropriate button to select the
audio source you would like to hear: CD,
FM, DAB/AM, FRONT, TV, AV, GAME or TAPE.
Where DAB is fitted, press
DAB/AM twice
to select AM.
Press
FRONT twice to select USB.
F
,
G
Adjusts the amplifier volume.
B
,
C
F
,
G
and OK
The
B
and
C
keys are used to
navigate the System menu,
F
and
G
to
adjust the settings, together with the OK
button (see pages 16).
-
Press once to mute the speaker and
pre-amp outputs of Solo Mini. Press for
a second time (or adjust the volume) to
unmute the unit.
MENU
In ‘Clock mode’ (red light), the MENU
button enters the Alarm setting menu
(see page 18). In ‘Power on’ mode (blue
light) MENU enters the System menu (see
page 16). Press the MENU button for a
second time to leave the menu.
To Next Page
Loading...
