EasyManua.ls Logo

Arcam SOLO MINI - Clock and Sleep Timer Settings; Setting the System Clock

Arcam SOLO MINI
21 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
E-17
solo
mini
English
clock/
alarm
Setting the clock
When Solo Mini is in clock mode (POWER light showing
red), press MENU to set the clock or alarms.
Use the
F
and
G
buttons on the remote control to
select the item to change, then use the
B
and
C
buttons to change the value.
For example, after pressing
MENU to enter the clock/
alarm setting menu, pressing up and down will change
between setting the clock and setting one of the alarms.
Retaining clock settings
If Solo Mini is turned off at the mains supply, clock
settings are retained for approximately four days. In
Clock mode, clock settings are retained indefinitely.
Setting the front panel clock
The procedure is shown on the diagram above, but the instructions are:
1. Power off the unit, using the top panel POWER button, or the remote control
2
button. The light next to the top panel POWER button glows red, showing that the
unit is in Clock mode.
2. Press the remote control MENU button once.
3. Press
B
once to enter the Clock Set screen.
4. Press
G
to highlight 12HR or 24HR; toggle with the
BC
cursor keys.
5. Press
G
to move to the hours; adjust with the
BC
cursor keys.
6. Press
G
to move to the minutes; adjust with the
BC
cursor keys.
7. Press
G
to move to set the day; adjust with the
BC
cursor keys.
8. Press
G
to move to Set? and confirm with OK.
Press the
2
(power) button to save and exit the menu.
Time synchronization
For DAB radio with time synchronization set to ‘Auto’,
the clock will be synchronized to the broadcast time
when DAB radio is selected each day. The default value is
‘Man’ (manual clock setting).
As clock synchronization is periodic, it is recommended
that the clock is set manually at times of daylight saving
changes – especially if you need to use the alarm feature!
Sleep timer
This timer allows you to specify a listening period, after
which the volume fades into the (silent) Clock mode.
The period can be set in 5-minute intervals, up to
120 minutes (2 hours).
To set the sleep timer, press the
MENU key on the remote
control to access the System menu (see page 16).
Earlier
Later
Previous
Next
Previous
Next
Set AM/PM
(12hr only)
Set 12/24
hour clock
Clock
synchronization
12hr
24hr
Auto
Manual
Earlier
Later
Set the hours
Set the minutesSet the dayConfirm settings
Exit to
time-of-day
display













MENU
OK
MENU





Related product manuals