Pre-amplifier
Inputs
Maximum input level 2.5Vrms
Input impedance 47kΩ
Signal/noise ratio 105dB
Co-axial outputs
Maximum output level 2.5Vrms
Output impedance 500Ω
Amplifier
Continuous power output, per channel, 80kHz measurement bandwidth
Both channels, 8Ω, 1kHz 25Wrms, 0.1% THD+n
Distortion, both channels 8Ω, 80%
power, 1kHz
0.036% THD+n
CD playback
DAC Wolfson 24-bit multilevel Delta-Sigma DAC
Frequency response (±0.5dB) 20Hz–20kHz
DAB receiver (where fitted)
RF tuning range 174–240MHz (Band III)
1452–1490MHz (L-band)
Number of DAB presets 10
Sensitivity (typical) –98dBm (VHF measurement to EN50248)
Input impedance 50Ω
Audio data rate (maximum) 256kbits/s MPEG layer II, protection level 3
FM receiver
RF tuning range 87.5–108MHz (Europe and USA)
77.5–108MHz (Japan)
Number of FM presets 30
Sensitivity (typical) 2µV
Signal/noise ratio (at 200mV) 58dB
Distortion (THD at 200mV) 0.5%
AM receiver
RF tuning range 522–1710kHz, in steps of 9kHz (UK)
530–1710kHz, in steps of 10kHz (USA)
531–1629kHz, in steps of 9kHz (Japan)
Number of AM presets 30
Signal/noise ratio (at 200mV) 40dB
Distortion (THD at 30% modulation) 1.5%
General
Supply voltage* 100V, 115V or 230V AC,
depending on shipping region
Power consumption Clock mode 4W
Operational 80W (typical), 250W
(maximum)
Size (W x D x H) W230mm x D350mm x H90mm
Weight (net) 5.31kg
Weight (packed) 6.7kg
Supplied accessories Mains lead
Solo remote control handset and two AAA
batteries
Instruction manual and registration card
DAB/FM model: DAB Telescopic aerial, FM
dipole aerial and AM loop aerial,
AM/FM model: FM dipole aerial and AM loop
aerial
* In Japan, the supply voltage is 100V, 50–60Hz.
E&OE. All specification values are typical unless otherwise stated.
technical
specification
To Next Page
Loading...
