system
menu
Configuring the listening settings
Solo Mini allows you to adjust listening settings to suit
your taste, and to customise various system features.
Use the adjacent diagram to navigate through the items
available.
With the unit switched on (blue light showing), press
MENU on the remote control. Now use the
C
and
B
keys on the remote to move down and up the settings
available. The
F
and
G
keys on the remote are used to
adjust particular settings.
To leave the menu at any time, press
MENU again.
Balance
Balance allows you to increase the volume of one
channel (left or right) relative to the other. Altering the
balance may help to restore the stereo image for an off-
centre listening position.
Bass
This setting increases or decreases the lower frequency
components of your music.
Treble
This setting changes the relative volume of the higher
frequency components of your music.
Sleep Timer
This timer allows you to specify a listening period, after
which the volume fades into the (silent) clock mode. (See
page 17)
CD AutoPlay
(Applies only if source is
CD.)
This setting controls the handling of a CD inserted into
the front slot. If enabled, the CD plays immediately; if
disabled, the CD waits for a command from the remote
or top panel.
Prog
(Applies only if source is
CD and a CD is loaded.)
This feature allows you to programme the playing
order of CD tracks. Scroll left or right to highlight any
of the available tracks and press
OK to transfer it to the
playback sequence.
FM Mode
(Applies only if source is
FM.)
In some weak signal areas, switching the FM tuner to
‘Mono’ can be of benefit, as mono requires a much lower
signal strength to produce acceptable results. If the signal
strength in your area is good, leave FM Mode in ‘Stereo’.
DAB Setup
(Applies only if source is
DAB.)
Selecting ‘Scan’ (confirm with
OK) causes Solo Mini to
search for new DAB stations. Found stations are added
automatically to the list of available stations.
Scanning for new stations does not erase stations that
are no longer transmitted – over time, or if you change
location, this may lead to you having stations in your list
that cannot be received. In this case, select ‘Erase settings’
(confirm with
OK), then perform a new scan. When the
scan is complete, only stations that are currently available
in your area are shown.
Store/Erase Preset
This allows you to store a radio station that you have
tuned in to as a numbered preset (confirm with
OK).
The station can then be retrieved by pressing the preset
number on the remote.
In the same way, you can erase a particular numbered
preset (confirm with
OK).
iPod Option
(Applies to TAPE input with rLead connected)
This allows you to Enable or Disable control of an iPod
when connected via an Arcam rLead (for rDock, this
feature is automatic).
To Next Page
Loading...
