Arcam SR250 - Using Zone 2

E-18
Using Zone 2
Zone2 provides the option for the occupants of the
master bedroom, conservatory, kitchen, etc. to view or
listen to a dierent source at a dierent volume level
from the main zone (Zone1).
Source selection and volume control for Zone 2 is
achieved:
< by using an IR receiver in Zone 2 (see “Zone2
control connections” on page E-37), or
< by switching over to Zone 2 control by pressing the
front panel zone button, or
< by pressing AMP + OK on the remote control.
e front panel VFD display indicates that control has
been switched to Zone 2.
STANDBY Z2 50
To turn on Zone 2, with the remote, AMP + OK then press
the standby power button on the remote control or press
ZONE button on the front panel and then release it to
select zone 2, then press and hold the ZONE button on
the front panel to turn on Zone 2. Press a source select
button to select a dierent source to Zone 1.
FOLLOW Z1 Z2 50
Note that Zone 2 control from within Zone 1 will pass
automatically back to Zone 1 control aer a few seconds
of inactivity.
Zone 2 can also be controlled using a third-party
programmable remote control or a home automation
system. Please contact your dealer or installer for
further details.
Extended front panel menu
Pressing the MENU key on the front panel and holding it
for longer than four seconds will bring up the Extended
Menu, allowing you to perform the following:
Restore to factory defaults
is option allows you to restore all settings on your
Receiver to the defaults that it le the factory with.
Change remote code
e default RC5 system code the Receiver responds to
is 16. If required, for example due to another device in
your system also using this RC5 system code, it can be
changed to 19.
Restore secure backup
is option allows you to restore all settings to their
state as saved using the ‘Store secure backup’ feature.
is option is useful if settings are accidentally changed.
It also allows the unit to be returned to the saved state
following a rmware update.
Store secure backup
is option allows you to save all the Receiver settings to
a secure area of memory. e settings can be retrieved
using the Restore option above.
– Enter PIN
Enter the secure backup PIN using the
'
,
<
,
>
and
,
keys on the remote control (do not use the
numeric keypad). The default PIN is 0000.
– Change PIN
Allows the PIN to be changed to a number other
than the default. Enter the current secure backup
PIN using the
'
,
<
,
>
and
,
keys on the
remote control (do not use the numeric keypad).
The default PIN is 0000. After the current PIN has
been entered correctly, enter a new PIN as prompted
and again to confirm.
– EXIT
Cancel and return to the extended menu.
Updating firmware via USB
e rmware in your Receiver can be updated from a
USB ash drive containing rmware update les.
You can download the latest rmware le, together
with upgrading instructions, from the Arcam website
(www.arcam.co.uk).