20
6. STRAP INSTALLATION
Step 1: Pull out one side through the strap
hole on the back panel with hook side of the
velcro up.
Step 2: Pull out it to well stick hook side of the
velcro to loop side and across the nylon
buckle.
Repeat it on the other side.
Step 3: Repeat it on the front panel. Pull out
one side through the strap hole on the back
panel with hook side of the velcro up.
Pull out it to well stick hook side of the velcro
to loop side and across the nylon buckle.
Step 4: Proper state after installation:
1. Strap does not twist;
2. Buckle side of shoulder pad is up, while its
flat side faces the machine (as shown in the
picture);
3. Straps are well locked.
Digital Welder Expert, Know You More
https://www.arccaptain.com
To Next Page
Loading...
