3
2. INTRODUCTION
2.1 How To Use This Manual
To ensure safe operation, read the entire manual, including the chapter on safety instructions and
warnings.
2.2 Receipt of Equipment
When you receive the equipment , check it against the invoice to make sure it is complete and
inspect the equipment for possible damage due to shipping. If there is any damage, notify the
carrier immediately to file a claim. Furnish complete information concerning damage claims or
shipping errors to the location in your area listed in the inside back cover of this manual. Include all
equipment identification numbers as described above along with a full description of the parts in
error. Move the equipment to the installation site before un-crating the unit. Use care to avoid
damaging the equipment when suing bars , hammers, etc., to nu-crate the unit.
2.3 Description
This MIG130 takes the guess work out of welding with an impressive SYNERGIC SET function that
allows the user to weld like a Pro with no previous welding experience necessary.
2.4 Duty Cycle
The rated duty cycle of a welding power source, is a statement of the time it may be operated at its
rated welding current output without exceeding the temperature limits of the insulation of the
component parts. To explain the 10 minute duty cycle period the following example is used.
Suppose a welding power source is designed to operate at a 20% duty cycle, 120 amperes at 20
volts. This means that it has been designed and built to provide the rated amperage (120A) for 2
minutes, i.e. Arc welding time, out of every 10 minute period (20% of 10 minutes is 2minutes).
During the other 8 minutes of the 10 minute period the welding power source must idle and be
allowed to cool.
Digital Welder Expert, Know You More
https://www.arccaptain.com
To Next Page
Loading...
