C-2 INSTALLATION C-2
Do not attempt to use this equipment until you have thoroughly read all operating
and maintenance manuals supplied with your machine. They include important
safety precautions, detailed operating and maintenance instructions and parts lists
ELECTRIC SHOCK can kill
Do not touch electrically live parts or electrode with skin or wet clothing
Insulate yourself from work and ground
Always wear dry insulating gloves.
Only qualified personnel should install, use or service this equipment.
Location and Ventilation
Whenever you use the arcweld
®
180C MIG Inverter MIG/Stick/TIG Welder be sure that
clean cooling air can flow around the front and rear louvres, (there should be 500mm
clearance for good ventilation). Avoid dusty, dirty areas, particularly if conductive
particles are present in the cooling air. Also keep the machine away from heat sources.
If operation is to be outdoors protect from rain and do not sit in puddles or otherwise
submerge it in water. Such practices pose safety hazards and cause improper
operation and corrosion of parts.
Always operate the arcweld
®
180C MIG Inverter Welder with all panel work installed to
enable correct cooling air flow and protect you from possible electric shock.
Storing
Store the machine in the permissible range of -25 ~ +55℃, in a dry place when it is not in
use. Protect it from dust and dirt. Keep it were it cannot be .accidentally damaged
from construction activities, moving vehicles and other hazards.
Stacking
The arcweld
®
180C MIG Inverter Welder CANNOT be stacked.
Tilting
Place the arcweld
®
180C MIG Inverter Welder on a secure, level surface whenever you
use it or store it. Any surfaces you place it on other than the ground must be firm, non-
skid and structurally sound.
To Next Page
Loading...
