EasyManua.ls Logo

AREA iCOOL 4.5MHP - Page 22

AREA iCOOL 4.5MHP
49 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
v.18-12.01
Area Cooling Solutions Sp. z o.o. Ul. Relaksowa 27
55-080 Nowa Wieś Wrocławska
Ukraine phone/fax +38 044 411 42 38
TEHNOHOL LCC
21/49
и снизить риск затопления компрессора жидким
хладагентом.
Если испаритель расположен выше компрессора (что
часто встречается в больших установках),
рекомендуется откачать хладагент перед остановкой
компрессора. Если нет возможности откачивания,
всасывающая линия должна обеспечивать слив
хладагента в испаритель. Это защитит компрессор от
затопления во время простоя. Если испаритель
расположен ниже компрессора, на вертикальных
линиях должны быть масляные петли.
and reduce the risk of flooding the compressor
with a liquid refrigerant.
If the evaporator is situated higher than the
compressor (which is common in large
installations), it is recommended to pump down
the refrigerant before stopping the compressor.
If there is no pump down option, suction line
should ensure siphoning refrigerant in the
evaporator. It will protect the compressor from
flooding during standstill. If the evaporator is
situated below the compressor, there should be
oil locks on vertical lines.
Двойной трубопровод / Double rises
В установках, работающих с изменяющимися
нагрузками и с регулируемой
производительностью, следует использовать
двойной трубопровод на вертикальной линии
всасывания:
In units working at changing loads and with
adjustable capacity, a double riser on suction
vertical line should be used.

Table of Contents

Related product manuals