Argo Explorer XRT 1000 LE - Air Cleaner

32
WARNING!
Always use parts cleaning solvent to clean the sponge material. Never use low-flash-point
solvents or gasoline to clean the sponge material because the engine could catch fire or
explode.
Specified spark plug: NGK DCPR8E
3. Measure the spark plug gap with a wire thickness gauge and if
necessary, adjust the gap to specification.
Spark plug gap: 0.7~0.8 mm
To install the spark plug
1. Clean the surface of the spark plug gasket and its mating surface and then
wipe off any grime from the spark plug threads.
2. Install the spark plug with the spark plug wrench and then tighten it to the specified torque.
Tightening torque: 19.6 +/- 1.96 Nm
NOTES:
If a torque wrench is not available when installing the spark plug, a good estimate of the correct
torque is 1/4-1/2 turn past finger tight. However the spark plug should be tightened to the
specified torque as soon as possible.
3. Install the spark plug cap.
10. AIR CLEANER
1. Lift and Open the access cover.
2. Follow the direction arrow to loosen and remove the element.
3. Clean the element with non-flammable or high-flash point solvent and then squeeze it
completely dry.
Squeeze the excess solvent out of the sponge material and let it dry.
NOTES: The sponge material should be wet but not dripping.
CAUTION!
Do not twist the sponge material when squeezing it.
Apply foam air filter oil or other quality foam air filter oil to the sponge material.