EasyManua.ls Logo

Argo Explorer XRT 1000 LE - Cleaning and Storage

Argo Explorer XRT 1000 LE
66 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
56
CAUTION!
Some maintenance items need more frequent service if you are riding in unusually wet,
sandy or muddy areas or at full throttle.
Hydraulic brake service
Regularly check and if necessary correct the brake fluid level.
Every two years replace the internal components of the brake master cylinder and
calipers and change the brake fluid.
Replace the brake hoses every four years and if cracked or damaged.
Remove the carbon deposits in cylinder head, piston and exhaust system when power is
obviously lower than normal.
Perform maintenance and check when continuous abnormal misfire, after-fire and
overheating occurs.
Have your ATV serviced and checked by an authorized dealer. Ensure the service book is stamped
and signed. Failure to do so could invalidate your warranty.
The maintenance schedule is based on months of use or kilometers traveled. Do the scheduled
maintenance based on whichever comes first.
CLEANING AND STORAGE
Cleaning
Frequent, thorough cleaning of your ATV will not only enhance its appearance but will improve its
general performance and extend the useful life of many components.
1. Before cleaning the ATV:
a. Block off the end of the exhaust pipe to prevent water entry. A plastic bag and strong rubber
band may be used.
b. Make sure the spark plug and all filler caps are properly installed.
2. If the engine case is excessively greasy, apply degreaser with a paintbrush. Do not apply
degreaser to wheel axles.
3. Rinse the dirt and degreaser off with a garden hose. Use only enough pressure to do the job.
4. Once most of the dirt has been hosed off, wash all surfaces with warm water and mild,
detergent-type soap. An old toothbrush or bottlebrush is handy for hard to reach places.
WARNING!
Wet brakes may have reduced stopping ability, increasing the chance of an accident. Test
the brakes after washing. Apply the brakes several times at slow speeds to let friction dry
out the linings.
Excessive water pressure may cause water seepage and deterioration of wheel bearing,
brakes, transmission seals and electrical devices. Many expensive repair bills have
resulted from improper high-pressure detergent applications such as those available in
coin-operated car washers.