NOTES:
Dispose of lubricant in accordance with local regulations.
4. Install the drain bolt and its new gasket and then
tighten the bolt to the specified torque.
Tighten torque: 32.36 Nm or 24 ft. lb
5. Refill with the recommended final gear oil to the
brim of the filler hole as shown.
Oil quantity: 85W-90, 0.5 L
6. Check the oil filler bolt gasket for damage and
replace it if necessary.
7. Install the oil filler bolt and its gasket and then tighten
Tighten torque: 32.36 Nm or 24 ft. lb
8. Check the final gear case for oil leakage. If oil is leaking, check for the cause.
15. SEAT
To remove the seat
1. Open the lock by turning the key.
2. Pull up the seat at rear.
To install the seat
Insert the tongue on the front of the seat into seat
holders and push down on the seat at the rear. Make
sure that the seat is securely fitted.
16. FUEL TANK
The refill port is on the right of rear bumper.
There is a sight glass can check the fuel over full tank during refilling.
17. STORAGE COMPARTMENTS
This ATV equipped with two storage compartments, which are located at the front right and left
side. To access the storage compartment, insert the key and turn, and remove the storage
compartment cover.
When storing any documents in the storage compartments, be sure to wrap them in a plastic
bag so that they will not get wet. When washing the ATV, be careful not to let any water enter
the storage compartments.
To Next Page