Argo Explorer XRT 1000 LE - Transmission Gear Oil Change; Transmission Gear Oil Change Procedure; Front Differential Gear Oil Check; Front Diff Oil Level Check

35
3. Remove the transmission gear oil drain bolt and its
washer to drain the oil from the transmission case.
NOTES:
Dispose of lubricant in accordance with local regulations.
4. Install the drain bolt and washer then tighten the bolt to the specified torque.
Tighten torque: 32.36 Nm or 24 ft. lb
5. Loosen the clamp and remove the breather hose
then refill with recommended transmission oil.
Oil quantity: 75W/140, 0.75 L
6. Install the breather hose and tighten the clamp.
7. Check the transmission case for oil leakage. If oil is
leaking, check for the cause.
13. FRONT DIFFERENTIAL GEAR OIL
The differential gear case must be checked for oil leakage before each ride. If any leakage is
found, have an authorized dealer check and repair the ATV. In addition, the differential gear oil
level must be checked and the oil changed as follows at the intervals specified in the periodic
maintenance and lubrication chart.
To check the differential gear oil level
1. Place the ATV on a level surface.
2. Remove the differential gear oil filler bolt and its gasket and then check the oil level in the
differential gear case. The oil level should be at the brim of the filler hole.
Filler bolt
Drain bolt
Check bolt
3. If the oil is below the brim of the filler hole, add sufficient oil of the recommended type to
raise it to the correct level.
4. Check the gasket for damage and replace it if necessary.
5. Install the oil filler bolt and its gasket and then tighten the bolt to the specified torque.
Tighten torque:
Differential gear oil filler bolt: 32.36 Nm
check bolt: 7.8 Nm
To change the differential gear oil
1. Place the ATV on a level surface and raise
up.
2. Place an oil pan under the differential gear
Drain bolt