11. ENGINE OIL AND OIL FILTER
The engine oil level should be checked before each ride. In addition, the oil must be changed
and the oil filter replaced at the intervals specified in the periodic maintenance and lubrication
chart.
To check the engine oil level
1. Place the ATV on a level surface.
2. Check the engine oil level on a warm engine.
NOTES:
If the engine was started before checking the oil level, be sure to warm up the engine
sufficiently and then wait at least ten minutes until the oil settles for an accurate reading.
3. Remove the engine oil filler cap then wipe the engine oil dipstick off with a clean rag.
4. Insert the dipstick into the filler hole (by screwing it in) and then remove it again to check the
oil level. NOTE: the dipstick is common between 1000cc and 500cc models. Locate the
1000cc marking stamped into the dipstick and read the oil level on the dipstick in area
illustrated in the above photo.
NOTES:
The engine oil should be between the tip of the dipstick and the maximum level mark.
5. If the engine oil is not between the tip of the dipstick and the maximum level mark, add
sufficient oil of the recommended type to raise it to the correct level.
NOTES:
Be sure the engine oil is at the correct level, otherwise engine damage may result.
6. Insert the dipstick into the oil filler hole and then tighten the engine oil filler cap.
To change the engine oil (with or without oil filter replacement)
1. Place the ATV on a level surface and raise up.
2. Start the engine, warm it up for several minutes and then
turn off.
3. Place an oil pan under the engine to collect the used oil.
4. Remove the engine oil drain bolt and its washer to drain
the oil from the crankcase.
NOTES:
Dispose of lubricant in accordance with local regulations.
※ Skip the steps 5-7, if the oil filter cartridge is not being replaced.
5. Remove the cover and right internal fender.
To Next Page