EasyManua.ls Logo

Argo Relax - HOW TO USE THE APPLIANCE; Appliance Modes Overview

Argo Relax
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
20
V 12/14
The outlet must be between 40 cm and 100 cm off the ground. Avoid tight curves and folds in the hose.
When not using the air conditioner, disconnect the hose and fit
the closing cap.
Connect the power cord to a suitable electrical socket (230V). Insert the provided batteries into the remote control, making
sure to observe their indicated polarities. Select the desired operating mode from the remote control.
HOW TO USE THE APPLIANCE
This appliance can be used to Cool, Dehumidify and Fan.
When switching between modes, the fan continues operating but the compressor stops: the compressor will start again 3
minutes later. This delay protects the compressor from potential damage.
THE DISCHARGE TUBE MUST BE CONNECTED to the appliance AT ALL TIMES: the only exception is when the
appliance is used for Dehumidification only, in which case it is recommended that the appliance discharges
directly into the environment to obtain maximum efficiency (see the paragraph entitled "Dehumidification Mode").
Clean the air filters under the easily removable rear grille regularly to keep the air conditioner working efficiently.
Cool, Fan
Dry

Other manuals for Argo Relax

Related product manuals