25
V 12/14
from 0.5 to 24. Press the TIMER button to confirm. The T-OFF icon will remain on to indicate that the TIMER is
running.
Cancelling the timer: If the TIMER is set, press TIMER to display the delay. Press TIMER again to cancel the setting.
(8) TEMPERATURE AND ERROR DISPLAY
Problem Cause Solution
E5 Overcurrent protection. Pull out the plug and insert it again after 10 minutes.
If the problem persists, contact a service centre.
H8 Tank full. Empty the tank.
If the problem persists, contact a service centre.
F1 Temperature sensor failure. Contact a service centre.
F2 Evaporator temperature sensor failure. Contact a service centre.
F0 Refrigerant leak. Air conditioner out of
service.
Contact a service centre.
H3 The room temperature is in excess of
the appliance's operating range (over
35°).
The ventilation grilles are blocked.
Wait for the temperature to drop below 35°C.
Clear the obstruction to the ventilation grilles.
If the problem persists, contact a service centre.
SAFETY FUNCTIONS
LOCK REMOTE
Press + and - at the same time to lock the remote control.
The Lock icon will light up on the remote control, and it will not respond to commands.
SWITCHING BETWEEN °C AND °F.
Press - and MODE together to switch between °C and °F.
CARE AND MAINTENANCE
WARNING!
Before carrying out any cleaning or maintenance, unplug from the electric socket.
1. Cleaning the air filters
The air filter must be checked at least
once every two weeks of use.
Operating with dirty or blocked filters
will decrease the effectiveness of the
air conditioner and can cause serious
problems.
To remove the filter, release the rear
grille and carefully pull the filter out
sideways.
Use a vacuum cleaner to remove dust. If this is not
sufficient, wash it with lukewarm water and some neutral
detergent (if necessary), rinse it thoroughly in cold water
and leave to dry in air before restoring it. Once the filter
has been replaced, close the grille and return to using the
air conditioner.
To Next Page
Loading...
Need help?
General
