22
V 12/14
3. Screw the drain hose into the drain
hole and then secure it with the clip.
Fit the other end of the hose into the cap,
secure it with the clip and then run it
through the clamp.
Cooling
Ensure that when the unit is operating in Cool mode, the
rubber cap closing the drain hole on the back of the
appliance is in place.
To empty the container, switch the air conditioner off and
unplug. Remove the cap form the rear drain hole and
route its end over a normal drain.
Ensure that the tube is not twisted or bent. The tube must
slope downwards. Close the drain again with the cap, fit it
into the clamp, and resume use of the air conditioner.
Dry
WARNING!
When using the air conditioner in Dry mode, we
recommend always ensuring continuous drainage, in
order to guarantee maximum dehumidification
efficiency.
To empty the tank, switch the air conditioner off and pull
out its plug, remove the cap from the drain hole on the
back of the unit and route its end over a normal drain.
REMOTE CONTROL OPERATION
Insert the batteries into the remote control, respecting the indicated polarities.
Only use type AAA 1.5V batteries.
Remove the batteries if the remote control is not used for a month or
more.
Do not attempt to recharge the batteries. Change all batteries at the same time.
Do not throw batteries onto a fire, they may explode.
To Next Page
Loading...
Need help?
General
