EN - 13
CLEAN UNIT
1. Remove snow and debris with a soft-
bristled brush. DO NOT use harsh
abrasives or cleaners.
2. Protect painted surfaces with automotive-
type wax.
CHECK ENGINE OIL
See Check Engine Oil on page 10.
CHANGE ENGINE OIL
Refer to engine manual.
CHECK FASTENERS
Check for loose hardware.
CHECK AUGER PADDLE WEAR
Replace when auger paddles have worn
through wear indicator holes.
See Replace
Auger Paddles on page 13.
CHECK SCRAPER BLADE WEAR
Replace when damaged or when scraper
blade has been adjusted down as far as
possible and does not touch surface or clear
properly. Scraper blade MUST be replaced
when worn through to wear indicator pockets.
See Figure 10.
NOTICE: DO NOT allow scraper blade to
wear down too far or auger housing will
become damaged. See Replace Scraper
Blade on page 15.
CHECK BELT WEAR
Adjust auger cable as needed. Replace when
damaged or when auger stops or stutters
during operation.
See Adjust Auger Cable on
page 14 and Replace Belt on Page 15.
REPLACE AUGER PADDLES
Replace auger paddles when paddles have
worn completely through wear indicator
holes.
See Figure 11.
IMPORTANT: Always replace auger paddles
in pairs. Do not replace one paddle only.
Ariens 5W-30 Engine Oil
• 473 ml (16 oz)
• 946 ml (32 oz)
00091000
00067600
Auger Cable 06900533
Auger Belt 07200627
Auger Paddle Replacement Kit 53802900
Scraper Blade Replacement
Kit
53803100
Pawl Arm Replacement Kit 53803800
SERVICE &
ADJUSTMENTS
WARNING: AVOID INJURY. Read
and understand the
Safety section
before proceeding.
Figure 10
1. Wear Indicator Pocket
1
To Next Page
Loading...
