Programming manual for RD6203 Page 13
TESTING AND PROGRAMMING THE DIALLER
These are the menu steps for testing and programming the dialler:
Dialler Dialler Menu Digi Code Tel/Account Nbrs
(Default code 7812)
Dialler Default Default IRL
Connect to Line
Default [country]
Dialler Finished Previous Menu
Note: You cannot gain access to the dialler if the system is split or armed. If it is a split system, you must first
obtain extended access (located in the Maintenance menu). If the system is armed, you must first disarm it.
Testing the dialler:
This section explains how to test the dialler.
1. Access “Dialler” and press accept ü. Dialler
If “No privilege” is displayed a split system area is armed, or extended
access has not been obtained.
ü
üü
ü
Dialler Menu
2. Press the down arrow key ↓,and then press accept ü.
â
ââ
â and ü
üü
ü
Dialler Default
3. Press the accept key ü. The default for Ireland is displayed.
ü
üü
ü
Dialler IRL
4. To get the default for your own country, press the down arrow key ↓
until your country default appears. For example, Dialler UK.
â
ââ
â
Dialler UK
5. Press the accept key ü.
ü
üü
ü
Wait...
The dialler has now returned to default settings. Dialler UK
If the “Eng. Lock ON” display appears after accepting “Default
[country]“,and the engineers code is unknown, then the dialler cannot be
defaulted. Replace the dialler.
ü
ü
â
â
â
â
â
ü
To Next Page
Loading...
General