Page 50 Programming manual for RD6203
Dialling options (menu 2)
2.1 Methods of dialling Tone Pulse
2.2 Type of dialling tone (list)
2.3 Wait for dialling tone Yes No
2.4 Time between dialling attempts (seconds) 60 5
2.5 Dialling period (minutes) 0
2.6 Dialling attempts before error message “Dialler Fault” 4
Event delay (menu 4)
4 Delay period when report “delayed” (15 seconds) 3
Test Call (menu 6)
6.1 Waiting period before first test call (hours) 12
6.2 Time between 2 successive test call (hours) 24
Digi Engineer menu (menu 7)
7.1 Engineer code (standard 1278)
7.2 Engineer lock on Yes No
Line monitor (menu 8)
8.1 Line monitor active Off On
8.2 Operation of line monitor:
Abort call (no line fault in the “call” series equipment)
Permanent line monitor
Line monitor only when armed
8.3 Answer ringing when triggered No Yes
8.4 Check for presence of dial tone No Yes
Protocol options SIA1 (menu 5.2)
5.2.1 1 event per data block Yes No
5.2.2 1 Account number per call Yes No
5.2.3 2 or 3 digit event number 23
To Next Page
Loading...