2a. 2b.
2c. 2d.1a.
PELLET BOILER UNO
ARITERM SWEDEN AB Installation Instructions - 2008.05.21 - 9/28
Electrical connection of UNO
1. Remove the top panel
a) Two screws at the front/bottom edge; accessable behind the front doors.
b) Lift up the front edge a few centimetres. Put a suitable tool between the bot-
tom edge of the top panel and the side panels to keep the top panel in open
position.
2. Loosen the electric panel
a) Two screws at the top of each upper corner of the front panel.
b) Two M5-screws hold the electic panel towards the compressor bracket.
c) Two screws on each side above the front door hinges.
d) The electric panel is free to bend down to give access to the terminals.
To Next Page
Loading...
