Page 9 of 18
fluctuations.
When using the drive in an enclosure panel, install a cooling fan or air conditioner
in the area to ensure that the air temperature inside the enclosure does not
exceed the specified levels.
Do not allow ice to develop on the drive.
95% RH or less and free of condensation
Install the drive in an area free from:
• oil mist and dust
• metal shavings, oil, water or other foreign materials
• radioactive materials
• combustible materials (e.g., wood)
• harmful gases and liquids
• excessive vibration
• chlorides
• direct sunlight
Install the drive vertically to maintain maximum cooling effects.
NOTICE: Avoid placing drive peripheral devices, transformers, or other electronics near the drive as
the noise created can lead to erroneous operation. If such devices must be used in close proximity to
the drive, take proper steps to shield the drive from noise.
NOTICE: Prevent foreign matter such as metal shavings and wire clippings from falling into the
drive during installation. Failure to comply could result in damage to the drive. Place a temporary
cover over the top of the drive during installation. Remove the temporary cover before startup, as
the cover will reduce ventilation and cause the drive to overheat.
To Next Page
Loading...
