5.6 Edit Sensor Names
Plug the keyboard into the socket on the base of the display.
(for panels with internal displays the socket is inside the panel on the back of the display PCB)
Enter the User Menu
Press the Silence button until the display shows:
Then Unlock the Memory for editing (see Appendix A)
If you know the Serial number of the unit whose label you wish to change, type it in on the keyboard, then
press Return. The units’ Sensor number and existing Label will be displayed. Press Return twice to move to
the “L_xxx” field (Location Label).
If you do not know the Serial number of the unit whose label you wish to change, but you do know the
Sensor number, press Return on the keyboard to move the cursor to the next field, then type in the Sensor
number of the unit and press Return.
Type the new label that you wish the unit to have and press Return to save it.
If the new label is shorter than the old label, use the space bar key to remove leftover characters.
Remember to re-lock the Memory (see Appendix A)
If you do not know either the Serial or the Sensor Number of the unit whose label you wish to change, press
Return so that the Sensor field is highlighted and use the Selection keys (above TX & Enable) to scroll up
and down through the units on the system until you reach the unit that needs changing.
Once you have reached the unit that you wish to change the label for, press Return on the keyboard
to move to the bottom line (Location Label field) and type the new label that you wish the unit to
have, press Return to save the new label.
If the new label is shorter than the old label, use the space bar key to remove leftover characters.
Remember to re-lock the Memory (see Appendix A)
To EXIT the USER Menu, turn the Keyswitch to Night and then back to the Day position.
5.7 Patient Name – NOT APPLICCABLE
Patient Keyfobs can be personalised with the Patient’s name if required. (default is Patient 1,Patient 2 etc)
To rename a Patient Keyfob plug the keyboard into the socket on the base of the display.
(for panels with internal displays the socket is inside the panel on the back of the display PCB)
Enter the User Menu
Press the Silence button until the display shows:
Then Unlock the Memory for editing (see Appendix A)
Press the buttons above TX & Enable lights, to scroll through the Keyfob sensor numbers until to
reach the keyfob number that you want to change the name for.
Type the new name and use the space bar to over type any remaining characters from the previous
label.
To Next Page
Loading...