Similar to the Help Call Unit this call point offers Emergency level of alarm only.
4.1 Call Levels
Emergency – Pull the Red pull switch on the unit.
4.2 Resetting Call Points
Push the Red Pull switch back into place, the LED will stop flashing and the unit will reset.
4.3 Battery Replacement
To replace the battery in the Affray Alarm unit, following a Low Battery fault, remove the four corner screw
covers with a small flat bladed screwdriver. Un-screw the four screws to release the front of the unit.
Remove the exhausted battery and dispose of in a safe way and replace with a new battery. Replace the
front cover and screw the front closed and replace the four corner screw covers.
The Emergency Alarm units require one battery per unit: re-order code: BAT-AAL.
To Next Page
Loading...