ARM Pool Alarm - Appendix A: Unlocking Memory

13
Before Editing Unit names, the memory must be “enabled”. To do this, Open Control Panel door and move
the jumper on LK1 so that it connects both “B” pins. When the memory is “enabled” the memory LED
illuminates on new panels only. (see below)
When the Memory is “Enabled”
this LED illuminates
To “Enable Memory”, a
memory jumper must connect
both “B” pins on LK1.
NOTE: (LOCKING MEMORY)
To Lock Memory after programming remove
the jumper from both “B” pins, (the Memory
LED will turn off) and park the jumper on one
pin only for future use.
Appendix A: Unlocking Memory