There are two types of Control Panel:
When the keyswitch is in the enable position, the
Silence Button is used to access the configuration menu.
2.1 Operation
For normal operation (no calls or alarms on the system) the panel display will show:
From time to time the Rx & TX leds will flash indicating that the system and devices are communicating.
2.2 Day/Night Mode.
The keyswitch on the front of the display module has 3 settings:
- Day
- Night
- Enable
Day and Night settings are for the normal operation of the system and are indicated by a D or N at the top left
of the display. These settings influence the type of response the system will show for any alarm, call or fault
that occurs on the system.
In Night mode a quieter sounder is used for all Calls on the system & faults will be displayed but without the
sounder making a noise.
The Enable key position activates the buttons on the front of the display such that system parameters may be
changed. The Silence button does not silence the sounder in this mode, but instead is used to access the
menu structure.
For Normal Operation the keyswitch
should be in the Day/Night position
and the light above the Enable button
should NOT be lit.
To Next Page
Loading...