Armstrong Emech G12 User Manual

Performance
The torques are at steady state speeds.
No allowance has been made for load inertia. For high inertia loads contact Armstrong.
Maximum allowable accelerations and decelerations are load dependent.
Use the configuration software supplied with the G1 actuators to set the actuator torque, speed, and accelerations.
These are typical characteristic curves. For individually certified actuator performance curves contact Armstrong.
The user must ensure the duty cycles and maximum torque values are not exceeded.
G12 Power Versus Speed and Motor Current
G13 Power Versus Speed and Motor Current
G13 Torque Versus Speed and Motor Current
G12 Power Versus Speed and Motor Current
Notes:
Motion Profile Curve
Armstrong International
221
Armstrong Blvd., Three Rivers, Michigan, 49093 - USA
Phone (269) 279-3602 Toll Free (888) HOT-HOSE (468-4673)
10
Designs, materials, weights and performance ratings are
approximate and subject to change without notice. Visit
armstrong international.com/emech for up-to-date information.

Armstrong Emech G12 Specifications

General

Brand	Armstrong
Model	Emech G12
Category	Controller
Language	English