Touchstone TM502 Telephony Modem User’s Guide 26
Getting Battery USB Ethernet
Safety Started Installation Installation Drivers Configuration Usage Troubleshooting Glossary
Installing the Telephony Modem
USB Drivers
Use this procedure to install USB drivers for the ARRIS Touchstone Te-
lephony Modem on a Windows operating system.
This procedure does not explain how to provision the Telephony Modem
or otherwise initiate actual service.
When you plug the Telephony Modem into the PC’s USB port, Windows
automatically detects the hardware and attempts to install the drivers.
Requirements
Make sure you have the following before attempting to install the USB
drivers:
• PC with:
— CD-ROM drive
—at least one free USB port
— one of: Windows 98SE, Windows 2000, Windows ME, or
Windows XP
— ARRIS USB Driver CD
Note: Windows 95 and Windows NT are not supported. Win-
dows XP, SP2 or newer, does not require the USB Driver CD.
• USB cable (provided)
•(for installations not using DHCP) IP address, subnet, gateway,
and DNS information
How to use this chapter
The following table lists the procedures for installing the USB drivers
on the computer. The procedure is the same regardless of operating
system used.
To Next Page
Loading...
