Arroyo Instruments TECSource 5305 - Safety Terms and Symbols

Page 4 · 5300 Series TECSource User’s Manual
this cable, with tinned ends for soldering into custom solutions, is
available as p/n 1261B.
 TECSource Cable, 10A, 2m (p/n 1262B)
Similar to the 1260B cable, but designed to support up to 10A of TEC
current, and also adds wiring for the remote sensor inputs. This cable
must be used when going above 5A. A pigtailed version of this cable,
with tinned ends for soldering into custom solutions, is available as p/n
1263B.
 4300/5300 Series 2U Rack Mount Kit, 1 unit (p/n 1401-RM-1)
4300/5300 Series 2U Rack Mount Kit, 2 units (p/n 1401-RM-2)
For installing your 5300 Series TECSource or 4300 LaserSource into
a standard 19” rack. The 1401-RM-1 is used when installing a single
instrument into a 2U rack space. For mounting two instruments side-by-
side, use the 1401-RM-2 rack mount kit. A 1401-RM-1 cannot be
converted to a 1401-RM-2, or vise versa, to be sure to purchase the
correct rack mount kit.
 10kΩ Thermistor (p/n 1600)
Accurate to ±0.2°C.
 RS-232 NULL Cable, 3m (p/n 1200-NULL)
 USB Cable, 3m (p/n 1201)
Safety Terms and Symbols
The following safety-related terms are used in this manual:
 Warnings (noted by the WARNING heading) explain dangers that
could result in physical injury or death;
 Cautions (noted by the CAUTION heading) explain conditions that
could result in damage to the instrument, other equipment, or your
device.
 Notes (noted by the NOTES heading) are not safety-related, and are
intended simply to point out important information.
If, at any time, any of the following conditions exist, or are suspected of existing,
discontinue use of the unit until it can be inspected by qualified service
personnel:
 Visible damage to the unit, including damage or stress caused during
product shipment;
 Storage of the unit outside the standard storage temperature or
humidity rating, or prolonged storage under harsh conditions;
 Failure to operate properly.
If needed, contact your distributor or Arroyo Instruments for service or repair to
ensure the safety of the product is maintained.